Need to separate your upper- lower unit Cobra gearcase ?
How to video for separating the upper / lower OMC Cobra outdrive to do
Upper gearcase outdrive repair
Lower unit stern drive repair
New gear needed
Clutch dog replacement
Bent prop shaft
Broken outdrive case
If you require upper gearcase or lower unit service or repair work in almost all cases the outdrive
will need to be separated.
The video listed below should aid in this task. Once stern drive has
been removed from boat taking unit apart should take about 1 hour. In most cases it will be easier to separate units that
the actual stern drive removal from the boat.
No special tool required and wrench size needed
listed in the video by T.C. Electronics/Marine service rep Wayne Coll. If you require more help contact our tech service rep
phone number is list at bottom of this page.
Propeller and prop hardware should be removed from
lower unit before sending unit out for repair. Upper gearcase should have u-joint shaft assembly removed and water pump area
cover and the three small one inch bolts stored with cover.